Full-Load Sensor Pcb; Face-Up Sensor Pcb - Canon SORTER S-82 Service Manual

D. Full-load Sensor PCB
1) Following the rear cover removal proce-
dure on Page 3-2, remove the rear cover.
2) Remove the 4 screws, disconnect the 4
connectors, and then take off the full-
load sensor PCB.
Screws

Full-load sensor PCB

Connectors
Figure 3-6-5
E. Face-up Sensor PCB
1) Following the front cover removal proce-
dure on Page 3-2, remove the front
cover.
2) Remove the screw, disconnect the con-
nector, and then take out the face-up
sensor PCB.
Screw
Connector

Face-up sensor PCB

Figure 3-6-6
CHAPTER 3
3 - 17