Canon SORTER S-82 Service Manual page 14

CHAPTER 1
C. Unpacking and Installation Procedure
Condensation will form on surfaces when brought into a warm room from the cold.
Condensation on the surfaces of the sorter can cause feeding failures. Therefore, when moving
the sorter to a warm environment, leave it packed in its box for at least an hour to acclimatize
to room temperature.
1. Unpacking the Sorter
1) Open the sorter packaging.
2) Take out the accessories. Confirm that the power cord, reversing tray, sorter adapter plate
and interface cable are included.
3) Remove the sorter from the box and stand it upright near the printer. Check that none of
the covers were scratched or deformed during shipment.
4) Remove the plastic bag from the sorter.
5) Peel off the packing tape, remove the guide rail packing materials, and then lower the guide
rail gently.
Packing materials
Note: 1. The guide rail will fall over once the packing tape is peeled off. Be sure to support
the guide rail when removing the packing tape.
2. Save the packing materials in case you have to move or transport the sorter in the
future, as they are needed for the movement or transportation.
1 - 6
Figure 1-4-1
Guide rail