Canon BJC-S830D Setup Instructions

1
Unpack the Printer
1 Carefully remove all items from the box.
S830D
Photo Printer
Paper Rest
Output Tray
Documentation
and Software Kit
Direct Interface Cables
CompactFlash™ Card Adapter
S830D Print Head Power Cord
Ink Tanks
BCI-6C Cyan BCI-6M Magenta
BCI-6BK Black BCI-6Y Yellow
BCI-6PC Photo Cyan BCI-6PM Photo Magenta
2
Prepare the Printer
Remove the shipping tape from the front
1
and sides of the printer. Peel off the protective
film from the LCD panel.
Protective Film
Shipping Tape
2 Plug the power cord into the back of the
printer and connect the other end to a
power outlet.
3 Press the POWER button.
POWER POWER
Lamp Button
4 Open the front cover. The print head holder
automatically moves to the center. Remove
the protective tape.
Protective tape
Serial number
Write down the serial number located to
the right of the print head. You will need
this later to register the product.

Start Here

Easy Setup Instructions
3
Install the Print Head
Remove the print head from its package.
1
2 Turn the print head over, then remove
the orange protective cap.
NOTE: Do not touch the electrical contacts.
Electrical contacts
3 Raise the gray lock lever.
4 Gently slide the print head into the holder.
The print head will rest at a slight angle.
Do not press it down.
5 Lower the lock lever and gently press
it down until it locks into place.
4
Install the Ink Tanks
1 Pull the orange tab off the yellow ink tank
(BCI-6Y), then remove and discard the
plastic wrapper.
2 Twist off and discard the orange
protective cap.
Protective cap
NOTE: To avoid spilling ink, never press on
the sides of an ink tank.
Insert the ink tank into the correct slot.
3
(Refer to the color guide on the print head.)
Press down gently until the ink tank locks
into place.
4 Insert the remaining five ink tanks into
their assigned slots.
5 Close the front cover and attach the
paper rest and output tray.
S830D
Photo Printer
5
Connect the Printer
To Your Computer
Turn the printer off.
1
IMPORTANT: Be sure the printer is
off before continuing, or the computer
will attempt to install the printer
driver before the printer is ready.
2 Connect one end of the USB cable
to the computer, the other to the printer.
USB Port
USB Cable
Continue with Step 6
on side two.