Replacing Center High-Mount Stop Lamp (Chmsl) Bulbs; Approach Lamp/Mirror Turn Signal Bulb Removal; To Change The Bulbs - Lincoln 2004 Aviator Owner's Manual

Lights

Replacing center high-mount stop lamp (CHMSL) bulbs

1. Make sure the headlamp switch is
in the OFF position and open the
liftgate.
2. Remove the upper portion of the
liftgate trim by grasping the lift gate
trim around the upper portion and
pull it towards the glass. Note: The
liftgate trim is attached at 8
locations with snap-in attachments.
3. Disconnect the electrical
connector to the CHMSL by
depressing the tab and pull to
separate the electrical connectors.
4. Use a 9mm torx hex
socket/wrench to unscrew the two
CHMSL bolts that attach the CHMSL
to the liftgate.
5. Grasp the CHMSL and pull it down to disengage the center snap-in
attachment.
6. Replace the lamp by following the above procedures in reverse order.

Approach lamp/mirror turn signal bulb removal

To change the bulbs:

1. Make sure the headlamp switch is
in the OFF position.
2. Remove the approach lamp/turn
signal lens from the mirror housing
using a standard flat screwdriver to
pry the lamp assembly out.
3. Pull the lens out to remove it
from the mirror assembly
108
2004 Aviator f/k/a Navigator LS (231)
Owners Guide (post-2002-fmt)
USA English (fus)