Replacing Tail/Brake/Turn/Sidemarker/Backup Lamp Bulbs; Replacing Liftgate Tail Lamp Bulb - Lincoln 2004 Aviator Owner's Manual

Lights

Replacing tail/brake/turn/sidemarker/backup lamp bulbs

The tail/brake/turn/sidemarker/backup bulbs are located in the tail lamp
assembly, one just below the other. Follow the same steps to replace
each bulb:
1. Make sure the headlamp switch is
in the OFF position and then open
the liftgate to expose the lamp
assemblies.
2. Remove the two screws from the
lamp assembly.
3. Pull the lamp assembly towards
the rear and side of the vehicle at
an angle, carefully removing it from
the vehicle.
4. Rotate the bulb socket counterclockwise and remove from lamp
assembly.
5. Pull the bulb straight out of the socket and push in the new bulb.
6. To complete installation, follow the removal procedure in reverse
order.

Replacing liftgate tail lamp bulb

1. Make sure the headlamp switch is
in the OFF position and then open
the liftgate to expose the fasteners.
2. Remove the two acorn nuts from
the lamp assembly.
3. Pull the lamp off by pulling
rearward on the lamp.
106
2004 Aviator f/k/a Navigator LS (231)
Owners Guide (post-2002-fmt)
USA English (fus)