Turn Signal/Multifunction Lever; Turn And Lane-Change Signals - GMC 2009 Yukon XL Owner's Manual

Turn Signal/Multifunction Lever

The lever on the left side of the steering column includes
the following:
G : Turn and Lane Change Signals
5 3 : Headlamp High/Low-Beam Changer
N : Windshield Wipers
L : Windshield Washer
5
: Rear Wiper Delay
Z
: Rear Wiper
= : Rear Wiper Wash
Flash-to-Pass.
Information for these features is on the pages following.

Turn and Lane-Change Signals

Move the lever all the way up or down to signal a turn.
Raise or lower the lever for less than one second
until the arrow starts to flash to signal a lane change.
This causes the turn signals to automatically flash
three times. It will flash six times if tow-haul mode is
active. Holding the turn signal lever for more than one
second will cause the turn signals to flash until you
release the lever.
The lever returns to its starting position whenever it is
released.
If after signaling a turn or a lane change the arrows
flash rapidly or do not come on, a signal bulb could be
burned out.
Have the bulbs replaced. If the bulb is not burned out,
check the fuse. See Fuses and Circuit Breakers on
page 5-115.
An arrow on the instrument
panel cluster flashes in the
direction of the turn or
lane change.
3-7