Table of Contents
Advertisement
To return the seat to the passenger position on a
Suburban, lift the load floor panels and latch them into
the seatback. On both models, remove the head
restraints by sliding them out of the seat cushion. Lift
the seatback up and push rearward all the way. Then,
lower the seat cushion until it latches in position.
After returning the seat to the passenger position, return
the head restraints to the top of the seatback. Pull
forward on the seatback and up on the seat cushion to
make sure that the seat is securely in place.
On Suburban models, to
create a load floor, release
the panels from the seatback
by pushing rearward on the
latch and fold them out to
cover the rear seat footwell.
If the latch plate portion of the center safety belt was put
in the center armrest when the seat was folded, take the
latch plate portion out and place it on the seat. That way,
the center position safety belt will be available for the
center rear seat passenger to use.
Entry to the Rear Seat (Suburban Second Seat)
The right side of the rear 60/40 split folding bench seat
has an easy entry feature. That makes it easy to get in
and out of the third seat, if you have one.
To operate the seat, move the lever at the side of the
seat down.
Tilt the seatback toward the front of the vehicle by
pulling the top of the seatback forward.
When you do, the seat bottom will release. Just pull the
seat forward until it stops.
yellowblue
1-11
Advertisement
Table of Contents
