Table of Contents
Advertisement
To determine if your garage door opener has this
"rolling code" feature, press the appropriate button on
the universal transmitter that was programmed. If the
red light flashes rapidly for one to two seconds, then
turns solid, your garage door opener has this feature.
To program a garage door opener with the rolling code
feature, do the following:
-
1. Program your hand
held transmitter to the universal
transmitter by following the steps provided under
"Programming the Transmitter" earlier in
this section.
2. Remove the cover panel from the garage door
opener receiver. It is located near the garage door
opener motor.
3. Locate the training button on the garage door opener
receiver. The exact location and color will vary
among brands.
4. Press the training button on the garage door opener
receiver for one to two seconds.
5. Return to your vehicle and press the programmed
button on the universal transmitter until the red light
flashes rapidly (about two seconds).
6. Release the button, then press it again to confirm
that it was programmed to the garage door
opener receiver.
You may now use either the universal transmitter or the
-
hand
held transmitter to open your garage door. If you
still have difficulty in programming and require
-
assistance, please call 1
800
Accessories
Accessories for the universal transmitter are available
from the manufacturer of the unit. If you would like
additional information, please call 1
yellowblue
-
-
355
3515.
-
-
-
800
355
3515.
2-67
Advertisement
Table of Contents
