Table of Contents
Advertisement
4-4
Laying the cable harness
NOTE!
Remove the transport safeguards which consists of cable ties (four around the cable har-
ness and one around each shield cable end).
1
Separate the cable harness.
2
Lay the stand cable harness in the cable duct, as shown in Figure 4, all the way to the
generator.
Figure 4 Laying the cable harness
The cable harness consists of four shield cables, see Figure 4.
Pos in fig. 4
Siemens-Elema AB
Solna, Sweden
Installing the generator and the stand
5
1
2
1
High voltage cable H1.
2
IONTOMAT signal cable X11.
Unit control cable X1.
Power supply cable X14.
3
Anode rotation cable X9.
Filament cable X8.
4
Mains supply cables:
L1
L2
Protective ground.
SPS-UD
RX B7-120.033.01.10.02
1 2
3
4
4
3
Description
05.98
MAMMOMAT 300
65 02 186
Advertisement
Table of Contents
