Table of Contents
Advertisement
The front axle portion of the diagram
on the indicator
will light up when you shift into four-wheel drive. A
slight delay between shifting and the pattern's lighting
is normal. If the pattern does not light up, or if the front
axle lights do not go out after you shift out of
four-wheel drive, have your dealer check your system.
Turn the INT LIGHTS switch located to the right of
your headlamp switch to dim your transfer case
indicator light when your headlamps or parking lamps
are on. This will also cause your instrument panel
lights to dim.
2HI:
This setting is for driving in most street and
highway situations. Your front axle is not engaged in
two-wheel drive.
4HI:
This setting engages your front axle to help drive
your vehicle. Use 4HI when you need extra traction,
such as on snowy or icy roads, or in most off-road
situations.
N SET PARK B R A m : shift to this neutral setting
only when your vehicle needs
to
be towed.
4LO: This setting
also engages your front axle to give
you extra traction and provides extra gear reduction.
You
may never need 4 L O . I t sends the maximum power
to a l l four wheels. You might choose 4LO if you were
driving off-road in sand, mud or deep snow and
climbing
or
descending steep hills.
You
can shift from 2HI to 4HI or from 4HI to 2HI while
the vehicle is moving. Do not press the transfer case
shift lever button when shifting from 2HI to 4HI or from
4 H I to 2HI. Your front axle will engage faster if you
take your foot off of the accelerator for a few seconds
after you shift.
To shift your transfer case into N SET PARK BRAKE:
1.
Stop the vehicle and shift your transmission into
NEUTRAL (N).
2. Set the parking brake. Your vehicle can roll unless
the brakes are applied.
3. Pull the transfer case shift lever into N SET
PARK BRAKE.
2-23
Advertisement
Table of Contents
