Service Tire Monitor System - Chevrolet 2008 Uplander Owner's Manual

Hide thumbs Also See for 2008 Uplander:
Table of Contents

Advertisement

SERVICE STABILITY SYSTEM
If your vehicle has StabiliTrak
there has been a problem detected with StabiliTrak
®
See StabiliTrak
System on page 4-7.
If this message turns on while you are driving, pull off
the road as soon as possible and stop carefully. Try
resetting the system by turning the ignition off and then
back on. If this message still stays on or turns back on
again while you are driving, your vehicle needs service.
®
Have the StabiliTrak
System inspected by your dealer/
retailer as soon as possible.
This message displays only while the ignition is in
ON/RUN. Press any of the DIC buttons to acknowledge
this message and to clear it from the screen.
This message continues to display for two seconds
if it has not been acknowledged when the engine
is turned off. It also re-displays for two seconds if the
message has been acknowledged, but the condition
still exists when the engine is turned off.
If the condition still exists, the message re-appears
when the engine is turned on.
3-72
®
, this message displays if
®
.

SERVICE TIRE MONITOR SYSTEM

This message displays if a part on the Tire Pressure
Monitor System (TPMS) is not working properly. The tire
pressure light also flashes and then remains on during
the same ignition cycle. See Tire Pressure Light on
page 3-43. Several conditions may cause this message
to appear. See Tire Pressure Monitor Operation on
page 5-58 for more information. If the warning comes on
and stays on, there may be a problem with the TPMS.
See your dealer/retailer.
This message displays while the ignition is in ON/RUN.
Press any of the DIC buttons to acknowledge this
message and to clear it from the screen.
This message continues to display for two seconds
if it has not been acknowledged when the engine
is turned off. It also re-displays for two seconds if the
message has been acknowledged, but the condition
still exists when the engine is turned off.
If the condition still exists, the message re-appears
when the engine is turned on.

Advertisement

Table of Contents
loading

Table of Contents