Chevrolet 2008 Uplander Owner's Manual page 171

Q
RES + (Resume/Accelerate): Push the lever up
to resume the cruise control speed, or to accelerate
when passing another vehicle.
J
(CRUISE CONTROL) ON/OFF
button on the end of the lever to turn the cruise control
on. Press it again to turn cruise control off.
If your vehicle has cruise
control, the lever is located
below the windshield
wiper control on the right
side of the steering wheel.
q
: Press the
R
SET — (Set/Coast/Decelerate): Push the lever
down to set the cruise speed. If the cruise speed
is already set this position can be used to coast
or decelerate from a higher speed.
R
CANCEL : Pull the lever to cancel the cruise
control speed.
Cruise control allows a speed of approximately
25 mph (40 km/h) or more to be maintained without
keeping your foot on the accelerator. This is helpful
on long trips. Cruise control does not work at speeds
below about 25 mph (40 km/h).
When the brakes are applied, the cruise control
shuts off.
If the vehicle is in cruise control and the Traction
Control System (TCS) begins to limit wheel spin,
the cruise control will automatically disengage. See
Traction Control System (TCS) on page 4-6. When road
conditions allow, the cruise control can be used again.
3-11