G. Hoist Shaft
Access Hole
H. Wheel Wrench
1. Put the tire on the ground at the rear of the vehicle
with the valve stem pointed down, and to the rear.
2. Separate the tire/wheel retainer (D) from the guide
pin. Pull the pin through the center of the wheel.
Tilt the retainer down and through the center
wheel opening.
Make sure the retainer is fully seated across
the underside of the wheel.
I. Jack Handle
Extensions
J. Spare Tire Lock
(If Equipped)
3. Attach the wheel wrench (H) and extensions (I)
together, as shown.
4. Insert the hoist end (F)
through the hole (G) in
the rear bumper and
onto the hoist shaft.
Do not use the
chiseled end of the
wheel wrench.
5-111