Easy Exit Seat - Chevrolet 2008 Silverado 1500 Pickup Owner's Manual

To recall the memory positions, the vehicle must be in
PARK (P). Press and release either button 1 or button 2
corresponding to the desired driving position. The seat,
outside mirrors, and adjustable throttle and brake pedals
will move to the position previously stored. You will hear a
single beep.
If you use the remote keyless entry transmitter to enter
your vehicle and the remote recall memory feature is on,
automatic seat, adjustable mirror, and adjustable pedal
movements will occur. See "MEMORY SEAT RECALL"
under DIC Vehicle Customization (With DIC Buttons) on
page 3-76 for more information.
To stop recall movement of the memory function at any
time, press one of the power seat controls, memory
buttons, power mirror buttons, or adjustable pedal
switch.
If something has blocked the driver's seat and/or the
adjustable pedals while recalling a memory position,
the driver's seat and/or the adjustable pedals recall may
stop working. If this happens, remove the obstruction
and press the appropriate control for the area that is not
responding for two seconds. Try recalling the memory
position again by pressing the appropriate memory
button. If the memory position is still not recalling,
see your dealer for service.

Easy Exit Seat

The control for this feature is located on the driver's
door panel between buttons 1 and 2.
With the vehicle in PARK (P), the driver's seat exit
position can be recalled by pressing the exit button.
You will hear a single beep, and the driver's seat
will move back.
If the easy exit seat feature is programmed in the Driver
Information Center (DIC), automatic seat movement will
occur when the key is removed from the ignition. See
"EASY EXIT SEAT" under DIC Vehicle Customization
(With DIC Buttons) on page 3-76 for more information.
The memory seat and easy exit features can also be
programmed using the DIC.
For programming information, see DIC Vehicle
Customization (With DIC Buttons) on page 3-76.
1-7