Advertisement
Power ON Function
This function allows you to select Button only, Keyboard 98
Password, Mouse Left or Mouse Right and Hot Key (Ctrl F1 to Ctrl F12) to
Power ON the system.
Note: If you choose Mouse Left or Mouse Right, you must exit & save from
the BIOS. Let the system boot up until it goes to the BIOS table
configuration, before this function will work. During Power OFF, double
click the left or right mouse button to Power ON the system.
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC)
installed on the system board and you wish to use it. If you install an external
FDC or the system has no floppy drive, select Disabled in this field.
The choice: Enabled, Disabled.
Onboard Serial Port 1/Port 2
Select an address and corresponding interrupt for the first and
second serial ports.
The choice: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.
UART Mode Select
This item allows you to determine which Infra Red (IR) function of
onboard I/O chip.
The choice: IrDA 1.0, Standard, ASKIR, HPSIR.
RxD , TxD Active
This item allows you to determine the active of RxD, TxD.
The choice: "Hi, Hi", "Lo, Lo", "Lo, Hi", "Hi, Lo".
IR Transmition delay
This item allows you to enable/disable IR transmission delay.
The choice: Enabled, Disabled.
3-33
®
Advertisement
