Table of Contents
Advertisement
Standby Time Out
This option specifies the length of a period of system inactivity while
in Full power on state. When this length of time expires, the computer enters
Standby power state. The settings are Disabled, 1 min, 2 min, 4 min, 8 min,
10 min, 20 min, 30 min, 40 min, 50 min, or 60 min. The Optimal and Fail-Safe
default settings are Disabled.
Suspend Time Out
This option specifies the length of a period of system inactivity while
in Standby state. When this length of time expires, the computer enters
Suspend power state. The settings are Disabled, 1 min, 2 min, 4 min, 8 min,
10 min, 20 min, 30 min, 40 min, 50 min, or 60 min. The Optimal and Fail-Safe
default settings are Disabled.
Throttle Slow Clock Ratio
This option specifies the speed at which the system clock runs in
power saving states. The settings are expressed as a ratio between the
normal CPU clock speed and the CPU clock speed when the computer is in
the power-conserving state.
Modem Use IRQ
This indicates which IRQ no. will be used by the Modem(if there is a
Modem).
Display Activity/IRQ3/IRQ4/IRQ5/IRQ7/IRQ9/IRQ10/
IRQ11/IRQ13/IRQ14/IRQ15
When set to Monitor, these options enable event monitoring on the
specified hardware interrupt request line. If set to Monitor and the computer
is in a power saving state, AMI
IRQ line. The computer enters the full on power state if any activity occurs.
®
AMI
BIOS reloads the Standby and Suspend timeout timers if
activity occurs on the specified IRQ line.
®
BIOS watches for activity on the specified
4-16
®
Advertisement
Table of Contents
