Table of Contents
Advertisement
Initialize I2O Devices
If set to Yes, BIOS will initialize I2O processors, I2O storage device,
and provide INT13 support for I20 storage device. If set to No, BIOS will not
initialize I2O processors and I2O storage device.
Floppy Access Control
This option sets the Floppy to Read-only or Read-Write.
Hard Disk Access Control
This option sets the Hard Disk to Read-only or Read-Write. During
the Read-only, if you try to write on the Hard disk, the system wil halt.
S.M.A.R.T. for Hard Disks
This option sets the SMART Function for the hard disk. The hard
disk need to have SMART function for this feature to work.
Boot up Num Lock
When this option is set to Off, AMI
key when the system is powered on. The end user can then use the arrow
keys on both the numeric keypad and the keyboard. The settings are On or
Off. The optimal default and Fail-Safe default settings are On.
®
PS/2
Mouse Support
When this option is set to Enabled, AMI
mouse. The settings are Enabled and Disabled. The Optimal and Fail-Safe
default settings are Enabled.
Primary Display
This option configures the primary display subsytem in the computer.
The settings are Mono(monochrome), 40CGA, 80CGA or VGA/EGA. The
optimal and Fail-Safe default settings are VGA/EGA.
Password Check
This option specifies the type of AMI
that is implemented. The Optimal and Fail-Safe default settings are Setup.
®
®
BIOS turns off the Num Lock
®
BIOS supports a PS/2
®
BIOS password protection
4-7
®
Advertisement
Table of Contents
