Eco Dect - Gigaset E380 A Care User Manual

ECO DECT

Deactivating the room monitor / cancelling the alarm
Deactivate room monitor:
Cancel the alarm:
Deactivating the room monitor remotely
The alarm is forwarded to an external destination number.
The receiving phone supports tone dialling.
If the alarm is activated via a VoIP connection, the DTMF signalling must take place
via SIP info or RFC2833 (
¤
Accept the alarm call
The room monitor is deactivated and the handset is in idle status. The room monitor settings
on the handset (e.g. no ringtone) will remain activated until you press the display key OFF.
The room monitor cannot be reactivated remotely.
Reactivate:
ECO DECT
The device range is set to maximum as default. This guarantees the best connection between
the handset and the base station. In idle status, the handset will not function (as it is not
transmitting). Only the base station will maintain contact with the handset via a low wireless
signal. During a call, the transmission power automatically adapts to the distance between the
base station and handset. The smaller the distance to the base, the lower the radiation.
To reduce the radiation further:
Reducing radiation by up to 80%
¤
. . . use
Range Change (
The range is also reduced with this setting.
It is not possible to use a repeater to increase the range.
62
¤
In idle status press the display key OFF
¤
During an alarm press the End call key
setting on the base station).
press the
p. 61
to select Settings
= off )
keys
OK ECO DECT OK Maximum