Mtp Video Settings - Extron electronics MLS 608 D Series User Manual

MTP Video Settings

RGB Delay
During switching, the MTP video output can be set to switch the input sync source first,
followed by the RGB portion of the signal. This brief delay allows the display to adjust to
the new sync signal before sending the picture, providing a glitch-free switch. RGB delay
can be set from 0 to 5 seconds in 0.5-second increments.
NOTE:
For information on the method of setting RGB Delay, see the DSP Configurator Help File.
Video Mute
The MTP and HDMI video output can be muted or unmuted.
For information on the method of muting or unmuting the video output, see the DSP
Configurator Help file.
Video Format
Video inputs 1 through 3 can be individually configured as composite video, S-video, YUV,
or RGB.
For method of formatting the video inputs 1-3, see the DSP Configurator Help file.
MTP Settings
For MTP input 4, the input skew, level, and peaking can be set. For the MTP output on the
MLS 608 D Series device, you can set the output skew and pre-peaking.
Figure 40.
The RGB delay only takes effect if the video input format is set to RGB.
MTP Settings Screens
MLS 608 D Series • DSP Configurator 57