Chevrolet 1998 Lumina Owner's Manual page 107

Headlamp High/Low Beam
To change your headlamps
from low beam to high
beam, or high to low, pull
the multifunction lever all
the way toward you. Then
release it.
When the high beams are on, a light on the instrument
panel also will be on.
Windshield Wipers
You control the windshield
wipers by turning the band
marked WIPER. For a
single wiping cycle, turn the
band
to
MIST. Hold it there
until the wipers start, then
let go. The wipers will stop
after one cycle. If you want
more cycles, hold the band
on MIST longer.
For steady wiping at low speed, turn the band to LO. For
high-speed wiping, turn the band further, to HI. To stop
the wipers, turn the band to
OFF.
You can set the wiper speed for a long or short delay
between wipes. This can be very useful in light rain or
snow. Turn the band to choose the delay time. The
closer to LO, the shorter the delay.
Be sure to clear ice and snow from the wiper blades
before using them. If they're frozen to the windshield,
carefully loosen or thaw them. If your blades do become
damaged, get new blades or blade inserts.
Heavy snow or ice can overload your wipers. A circuit
breaker will stop them until the motor cools. Clear away
snow or ice to prevent an overload.
2-31