Table of Contents
Advertisement
and start again when you turn on the
ignition or the PWR-VOL button. The
disc will begin playing at the point
where it had been stopped.
ST-PL (Stop-Play): Press to stop the
disc player; the radio will play. Press
again to play the disc (the player will
start playing the disc where it had
stopped earlier).
EJCT (Eject): Press to eject the disc; the
radio will play. The disc will start at
track 1 when you reinsert it. EJCT works
even when the radio or the ignition is off.
CD Player Anti-Theft Feature
Delco LOC II@ is a security feature that
can be used or ignored. If you ignore it,
the radio will play normally. If you use
it, your radio cannot be turned on if it is
stolen. These instructions will tell you
how to enter a secret code into the radio.
If battery power is lost for any reason,
the
secret code must be entered again before
your audio system can be turned on.
To Set the Anti-Theft System:
1. Write down any six-digit number and
keep it in a safe place. This is your
secret code.
2 . Turn the ignition on.
3 . Rotate the PWR-VOL knob to turn
the radio
off.
4.
Press station preset buttons 1 and 4
at the same time and hold until
"- -
-"
shows on the display. You now have
only 15 seconds between each of the
following steps.
5.
Press SET and
000
will appear on
the display.
6.
Press
SCAN
until the first digit of
your code appears.
7.
Press SEEK until the second and
third digits of your code appear.
8.
Press the TUNE knob
(000
will
appear on the display).
9.
Press SCAN until the fourth digit of
your code appears.
IO. Press SEEK until the fifth and sixth
11.
Press the TUNE knob (rEP will
12. Repeat steps 6 through
10.
Then
digits of your code appear.
appear for five seconds, then
000 )
.
press the TUNE knob again.
SEC
will appear, indicating that Delco
LOC I P is set, and your radio is
secure. If
"-
- -"
appears, the steps
were not successful and you must
repeat the entire procedure.
To Disable the Anti-Theft System:
Enter your secret code by following
these steps (you will have only 15
seconds between each step).
1,
Turn
the ignition on and the radio
off, then press station preset buttons
1 and 4. SEC will appear, showing
the radio is secure.
2 . Press
SET
and
000
will appear on
the display.
3 . Press
SCAN
until the first digit of
your secret code appears.
4 . Press
SEEK until the second and
third digits of your code appear.
5.
Press the TUNE knob
(000
will
appear on the display).
6.
Press
SCAN
until the fourth digit of
your code appears.
7.
Press SEEK until the fifth and sixth
digits of your code appear.
I03
Advertisement
Table of Contents
