Stihl RMA 2 RV Instruction Manual page 40

English
Fault LEDs on the
battery
Self-propulsion is
not working.
The lawn mower 3 LEDs illumi‐
stops during ope‐ nate red.
ration.
The lawn mower
vibrates excessi‐
vely during ope‐
ration.
The lawn mower
operating time is
too short.
The battery gets
stuck when fitting
it into the battery
compartment.
Charging fails to 1 LED illumina‐
start after fitting tes red.
the battery into
the charger.
40
Cause
The area around the
blade is blocked.
There is a fault in the
self-propulsion
mechanism.
The lawn mower is
too warm.
The blade is blocked. ► Pull out the activation key.
There is an electrical
fault.
The blade fastening
screw is loose.
The blade is not cor‐
rectly balanced.
The battery is not fully
charged.
The battery service
life has been excee‐
ded.
The area around the
blade is blocked.
The blade is blunt or
worn.
The resistance at the
blade is too great.
The guides or electric
contacts in the battery
compartment are
dirty.
The battery is too
warm or too cold.
Remedy
► Switch the lawn mower on in lower
grass.
► Clean the lawn mower.
► Consult a STIHL specialist dealer.
► Pull out the activation key.
► Remove the battery.
► Allow the lawn mower to cool down.
► Clean the lawn mower.
► Do not switch the lawn mower on too fre‐
quently within a short time.
► If working with self-propulsion engaged:
switch off self-propulsion.
► If working with self-propulsion disenga‐
ged: go forwards slower.
► Set a higher cutting height.
► Mow shorter grass.
► Remove the battery.
► Clean the lawn mower.
► Remove the battery and fit it again.
► Switch the lawn mower on.
► Tighten the screw.
► Sharpen and balance the blade.
► Fully charge the battery.
► Replace the battery.
► Clean the lawn mower.
► Sharpen and balance the blade.
► If working with self-propulsion engaged:
switch off self-propulsion.
► If working with self-propulsion disenga‐
ged: go forwards slower.
► Set a higher cutting height.
► Mow shorter grass.
► Clean the lawn mower.
► Leave the battery inserted in the char‐
ger.
Charging starts automatically as soon as
the permissible temperature range is
reached.
19 Troubleshooting
0478-131-9950-B