Konica Minolta FS-107 Service Handbook page 37

(4) Remove the E-ring and remove the cam shaft.
(5) Take out the 2 sets of set screws and remove the
set of 2 plate springs.
Set screws
(6) Take out 1 set screw and remove the plate.
(7) Remove the E-ring that affixes the belt gear, slide
the gear and remove the belt.
Caution: Be careful to not drop the pin inside the
gear.
1
Set screw
Plate
Pin
REVISED EDITION
1
1
Shaft
E-ring
Plate spring
E-ring
Belt
DATE
3-3
May 2000
(8) Remove the 5 E-rings and pull out the shaft from
the paper exit roller/A.
Caution: Be careful to not drop the pin inside the
paper exit roller/A.
Paper exit
roller/A
E-rings
Pin
E-rings
(9) Replace the paper exit roller/A.
(10) Install by reversing the removal procedure.
PAGE
3-3
FS-107
Shaft
Pin
METHOD
REPLACEMENT