Replacing The Stapler Cartridge - Konica Minolta FS-107 Service Handbook

(11) Refer to procedures 3 to 6 and remove the up/down
1
wire on the rear.
(12) Wind the up/down wire once around the lower
pulley (rear) in the clockwise, and string it to the
upper pulley (rear).
(13) Down the up/down wire strung to the upper pulley
(rear) to the lower pulley and wind it around 4 times
1
clockwise, and attach the metallic ball on the end to
the side of the lower pulley (rear).
(14) Attach the E-ring and affix the lower pulley (rear).
(15) Fasten the 2 set screws while pulling up the pulley
tension plate (rear), applying 3kg tension.
REVISED EDITION
1
[5]
1
(1) Operate the stapler cartridge replacing from the
(2) Turn the stapler cartridge replace knob on the
1
(3) Remove the old cartridge and push a new cartridge
DATE
3-5
May 2000

Replacing the stapler cartridge

operation panel. The stapler unit will move and
position itself to the front.
stapler unit.
Cartridge
replace knob
firmly in place.
PAGE
3-5
FS-107
Stapler unit
Stapler cartridge
METHOD
REPLACEMENT