Table of Contents
Advertisement
for
three
seconds. (The
E I " y
shown will be the last
PTY
selected.) Press the RDS SELECT button, followed by this
button again to turn the
PTY
display off.
< PTY >
(5)
(6): With RDS on, press the RDS
SELECT button, followed by
<
or
>
.
The PTY display
will turn on, if it is not already on. RDS SELECT PTY
NEWS will appear on the display for three seconds.
(The PTY shown will be the last PTY selected.) While
this message is displayed, use
<
and
>
to move up and
down the PTY list. If you pause on a PTY for three
seconds, PRESET
P T Y
NEWS will appear on the
display. While this message is displayed, you can save
the PTY in a preset by pressing one of the six numbered
pushbuttons until you hear a beep. Allow three seconds
for the message to disappear if you do not want to save
the PTY
in
a preset. See "Radio Data Systems (RDS)
Program Type (PTY) Selections'' in the Index.
When the PTY display is on, press SEEK and
SCAN
to
find radio stations of the PTY you want to listen to. The
last PTY selected will be used
for seek and scan modes.
If a station with the selected PTY is not found, NONE
FOUND will appear on the display. If both PTY and TA
are on, the radio will search for stations with traffic
announcements and the selected PTY.
PUSHBUTTONS: The six numbered pushbuttons let
you return to your favorite Program Types (PTYs).
These buttons have factory PTY presets. See "Radio
Data Systems (RDS) Program Type (PTY) Selections''
in the Index. You can set up to 12 PTYs (six F"1 and
six FM2). Just:
1. Turn PTY on.
2. Press BAND to select FM1 or mM2.
3. Tune an RDS station with the PTY you desire.
4. Press and hold one of the six numbered buttons for
more than two seconds until you hear a beep.
Whenever you press that numbered button for less
than two seconds, the PTY you set will return.
5. Repeat the steps for each pushbutton.
When battery power is removed and later applied, you
will not have to reset your RDS presets because the
radio remembers them.
HR or MN: Press the RDS SELECT button, followed
by one of these buttons to display the time
for the
current station. STATION TIME IS will be displayed. If
a time has not been sent to the radio, NO STATION
TIME will be displayed. If you have recently tuned to
the station, you may need to wait a minute before the
time is available to the radio. To set the clock to the
Advertisement
Table of Contents
