Mitsubishi MELDAS TRS50 Manual page 19

Item Check Signal
pin
10 ovc
CH34
Load meter
output
signal
Function
This signal is produced by rectifying
the U, V, W phase current and by
converting the current from AC to DC. It
can be used to check the response of the
current loop at CH30.
Note: CH30 current must be used with ap-
propriate damping.
Insufficient Appropriate
damping
Used when measuring current at load
meter output check pin.
Refer to voltage and current measurement
methods in (61-l) for output voltage.
-18-
Excessive
damping damping