Specifications - Mitsubishi MELDAS TRS50 Manual

This manual outlines the maintenance procedures for using the
replacing the transistor amplifiers as well as the inspection
locations and adjustments, and it should thus be read before
operating the AC servo system.
switching on the power.

(1) SPECIFICATIONS

Item
Motor used
Continuous output
current
Output torque (when
used in combination
with amplifier)
Rated output voltage
Alarm circuits
l
Power supply
Control loop
Control characteristics
INTRODUCTION
It details the methods involved in
Refer to the checkpoints before
TRS75
HA100
45Arms
458
kg.cm kg.cm
Fin overheating protection (FOH), power
unit alarm (PUAL), motor overloading
(MOH), TG over-speeding (TGOV), over-
current detection (OVC), instant over-
current protection (OCP), no-signal de-
tection (NSG), instant power failure
compensation and under-voltage
compensation (LVAL).
310V (DC) across P-N
(With AC 220V factory power supply)
Current loop (sine wave approximation,
Speed control band:
Speed control range:
TRS150
HA200
HA300
66Arms
709 1036
kg.cm kg.cm
500 rad/sec.