Fujitsu PRIMERGY PG-R1CK6 User Manual page 82

When converting the server from a rackmount model back to a
POINT
deskside model, update the chassis ID as follows:
1
Check that no media has been left in the floppy disk
drive, CD-ROM, etc.
2
Turn on the display and any attached peripherals.
3
Insert the "Hardware Configuration Tool Boot Floppy"
provided with the server in the floppy disk drive and
turn on the server.
The menu will appear.
4
Select "Server Management Tool" from menu and
press [Enter].
After appearing the DOS prompt, remove the "Hardware Config-
uration Tool Boot Floppy".
5
Insert the "Server Management Tools" disk provided
with the server into the floppy disk drive and type the
following commands:
A:\>WRTID.BAT F200R.ini
The following message appears when properly executed.
Normal END
6
Turn off the server.
15 Updating the Chassis ID
[Enter]
31
E