Buick 2007 Rendezvous Owner's Manual page 445

For vehicles with aluminum wheels, remove
the center cap by tapping the back of the cap
with the folding wrench.
3. Remove the J-hook and the wing nut from the
back of the jack access door. Assemble the
wing nut and the J-hook.
4. Install the wing nut and the J-hook to the
D-ring through the center hole of the tire.
5. Tighten the wing nut to secure the tire to
the floor.
Push and pull on the tire to make sure the tire
is secure and does not move.
6. Put back all tools as they were stored in the
jack storage compartment and put the
compartment cover back on.
Slip the tabs on the side of the compartment
cover into the cover opening. Push the cover in
place and push down the tabs on the cover
so that it rests in the groove. This secures the
cover in place.
Storing the Flat Tire (Vehicles
with a Rear Convenience Center)
A. D-Ring
B. Rear Convenience
Center
C. Wing Nut
D. J-Hook
1. Open the center storage compartment door of
the rear convenience center.
2. Remove the cap on the bottom of the storage
compartment and flip the D-ring up.
E. Full-Size Tire
F. Cap on Bottom of
Storage
Compartment
445