Buick 2007 Rendezvous Owner's Manual page 260

Do not add any label to a CD, it could get caught
in the CD player. If a CD is recorded on a
personal computer and a description label is
needed, try labeling the top of the recorded CD
with a marking pen.
Notice: If you add any label to a CD, insert
more than one CD into the slot at a time, or
attempt to play scratched or damaged CDs, you
could damage the CD player. When using the
CD player, use only CDs in good condition
without any label, load one CD at a time, and
keep the CD player and the loading slot free of
foreign materials, liquids, and debris.
If an error appears on the display, see "CD
Messages" later in this section.
1 (Reverse): Press and hold this pushbutton
s
to reverse quickly within a track. You will hear
sound at a reduced volume. Release this
pushbutton to play the passage. The elapsed time
of the track displays.
2 (Forward): Press and hold this pushbutton
\
to advance quickly within a track. You will hear
sound at a reduced volume. Release this
pushbutton to play the passage. The elapsed time
of the track displays.
260
4 RDM (Random): Press this pushbutton to hear
the tracks in random, rather than sequential,
order. Press RDM again to turn off random play.
EQ (Equalizer): Press EQ to select an
equalization setting while playing a CD. The
equalization is set whenever a CD is played. See
"EQ" listed previously for more information.
© ¨
SEEK : Press the left arrow to go to the
start of the current track if it has played more than
eight seconds. Press the right arrow to go to
the next track. If either arrow is held or pressed
more than once, the player continues moving
backward or forward through the CD.
To scan tracks, press and hold either SEEK arrow
for two seconds until SCAN displays and you
will hear a beep. The CD goes to the next track,
plays for a few seconds, then goes to the next
track. The sound mutes and SCAN and the track
number displays while scanning. The CD only
scans forward. Press either SEEK arrow again to
stop scanning.