Storage Areas; Glove Box - Buick 2006 LaCrosse Owner's Manual

Using Universal Home Remote
Press and hold the appropriate Universal Home Remote
button for at least half of a second. The indicator light
will come on while the signal is being transmitted.
Erasing Universal Home Remote
Buttons
To erase programming from the three Universal Home
Remote buttons do the following:
1. Press and hold down the two outside buttons until
the indicator light begins to flash, after 20 seconds.
Do not hold the two outside buttons for longer
than 30 seconds.
2. Release both buttons.
The Universal Home Remote is now in the train
(learning) mode and can be programmed at any time
beginning with Step 2 under "Programming Universal
Home Remote" shown earlier in this section.
Individual buttons cannot be erased, but they can be
reprogrammed. See "Reprogramming a Single Universal
Home Remote Button" following this section.
2-44
Reprogramming a Single Universal
Home Remote Button
To program a device to Universal Home Remote using
a Universal Home Remote button previously trained,
follow these steps:
1. Press and hold the desired Universal Home
Remote button. Do not release the button.
2. The indicator light will begin to flash after
20 seconds. While still holding the Universal
Home Remote button, proceed with Step 2 under
"Programming Universal Home Remote" shown
earlier in this section.
For additional information on Universal Home Remote,
see Customer Assistance Offices on page 7-4.

Storage Areas

Glove Box

To open the glove box, lift up on the lever. The glove
box may have a light inside and a shelf located at
the top of the glove box.