Lay-Out Of Uniguard Base Ug30/Mp30 Circuit - Trane mP30 Installation Operation & Maintenance

INSTRUCTION MANUAL

LAY-OUT OF UNIGUARD BASE UG30/mP30 CIRCUIT

The figure shows the rear of the
The following are shown in the figure:
- low down: connectors ("1" - "2" - "3"), with the analogue and digital inputs and outputs;
- lay-out for the clock circuit (optional);
- lay-out for the RS485 serial circuit (optional);
1 C5 C3/4
OUT5 OUT4 OUT2 OUT1
G0 B4
2
G B1
C6 NO6
3
NC6
6 (44)
UG30/mP30 control, with input and output terminals.
OUT3 C1/2 Y1
GND GND
B2 B3 ID2
GND +V ID1
C7
NO7
Y2
ID4 ID6 ID8 ID10
ID3 ID5 ID7 ID9
UG30 CONTROL
mP30-UG30 - Rev. 1.5 - Date: 18-03-2004 EN