Table of Contents
Advertisement
INSTRUCTION MANUAL
This manual describes the characteristics of the standard
The software version can be read by repeatedly pressing key
information must be supplied to the technical service centres when they are called in for a job.
The setting of some parameters on a special unit version may differ from those described in this manual.
Do not install the controls in places with the following characteristics:
- relative humidity above 80%;
- exposed to aggressive and polluting atmospheres (e.g.: sulphur or ammonia gasses, salt mists,
fumes) to avoid corrosion and/or oxidation;
- high magnetic and/or radio frequency interference (therefore, avoid installing units near transmitter
aerials);
Cut power before beginning work on the circuit in the case of assembly, maintenance or
replacement jobs.
In general, all the instructions found in the unit's Installation, Use and Maintenance Manual apply.
WARNING: In direct expansion air-conditioners with a three-phase power supply, the controller's power may be cut if
the phase sequence relay (RSF) is tripped.
4 (44)
PROGRAM IDENTIFICATION
UG30 and mP30
Version
1.6
WARNINGS
control for conditioners.
until your reach the "Hr" parameter; this
Parameter
Hr
mP30-UG30 - Rev. 1.5 - Date: 18-03-2004
UG30 CONTROL
EN
Hide quick links:
Advertisement
Table of Contents
