Table of Contents
Advertisement
If your vehicle is damaged in an accident, the headlamp
aim may be affected. Aim adjustment may be necessary
if it is difficult to see lane markers (for horizontal aim),
or if oncoming drivers flash their high beams at you (for
vertical aim). If you believe your headlamps need to be
-
re
aimed, we recommend that you take it to your dealer
for service; however, it is possible for you to re
your headlamps as described in the following procedure.
NOTICE:
To make sure your headlamps are aimed
properly, read all the instructions before
beginning. Failure to follow these instructions
could cause damage to headlamp parts.
To check the aim, the vehicle should be properly
prepared as follows:
D
The vehicle must have all four tires on a perfectly
level surface.
D
If necessary, pads may be used on an uneven surface.
-
D
aim
The vehicle should not have any snow, ice or mud
attached to it.
D
The vehicle should be fully assembled and all other
work stopped while headlamp aiming is being done.
D
There should not be any cargo or loading of the
vehicle, except it should have a full tank of fuel and
one person or 160 lbs. (75 kg) on the driver's seat.
D
Close all doors.
D
Tires should be properly inflated.
D
Rock the vehicle to stabilize the suspension.
Start with the horizontal aim. The adjustment
screws can be turned with an E8 Torx R socket or
T15 Torx screwdriver.
Once the horizontal aim is adjusted, then adjust the
vertical aim.
6-39
Advertisement
Table of Contents
