Bluetooth Headset; Connecting The Bluetooth Headset; Call Transfer - BMW X3 2021 Owner's Manual

Lower LED Meaning
above the
WLAN button
Is not lit. WLAN is deactivated.
Lights up green. WLAN is activated.

Bluetooth headset

Principle
In order to be able to use a Bluetooth® headset,
the Bluetooth® headset must be connected with
the snap-in adapter. A previously paired Blue‐
tooth® headset is automatically connected with
the snap-in adapter.
General information
If an additional Bluetooth® headset is paired, the
data of the previous Bluetooth® headset will be
deleted. Only one respective Bluetooth® head‐
set can be paired and connected at any time.
Functional requirements
▷ Depending on the Bluetooth® headset, the
pairing with the snap-in adapter is performed
automatically.
The Bluetooth® headset supports a fixed
passkey, which has been preassigned with
0000 and, if needed, can be modified at web
server http://192.168.1.1 on the Connectivity-
SIA2.0 page under BT Headset.
▷ The Bluetooth® headset is switched on; if
needed, the Bluetooth® headset must be
visibly switched on.
▷ The snap-in adapter is installed in the center
armrest.
▷ Ignition or standby state is switched on and
the vehicle key is in the vehicle.
▷ The SIM card is inserted in the snap-in
adapter or a mobile phone is connected via
the SIM Access Profile SAP with the snap-in
adapter.
Online Edition for Part no. 01405A39127 - VI/21
Rear phone
Connecting the Bluetooth®
headset
1. Press the
adapter for approx. 9 seconds, until the signal
tone sounds four times in quick succession.
The LED above the button flashes blue.
2. Turn on Bluetooth® headset; if needed,
switch it to visible.
3. Depending on the Bluetooth® headset, hold
the call key on the Bluetooth® headset down
to connect it with the snap-in adapter. Refer
to the operating instructions for the Blue‐
tooth® headset.
After the LED on the snap-in adapter turns
off, the Bluetoot®h headset has been con‐
nected.
Accepting a call
Incoming calls are shown on the hands-free sys‐
tem or the snap-in adapter.
The calls can also be accepted with a previously
connected Bluetooth® headset.
Press the call key on the Bluetooth® headset.
Establishing a call
With the Bluetooth® headset, the last dialed
number can be called using the hands-free sys‐
tem or the handset.
Press the call key on the Bluetooth® headset
twice.

Call transfer

General information
A call can only be carried out with one respective
end-user device:
▷ Via the hands-free system.
▷ Via the rear handset.
▷ Via the Bluetooth® headset.
COMMUNICATION
button on the snap-in
87