Grizzly G0926 Owner's Manual page 20

6. Attach wheel mounting bracket to bottom of
two legs with (2) M6-1 x 12 hex bolts, (4) 6mm
flat washers, (2) 6mm lock washers, and (2)
M6-1 hex nuts, as shown in Figure 13.
x 2
Wheel
Mounting
Bracket
Figure 13. Wheel-mounting bracket attached to
legs.
7.
Slide wheel axle through holes in wheel-
mounting bracket (see Figure 14).
8.
Slide wheels onto axle on outside of mount-
ing brackets, and secure with (2) cotter pins
(see Figure 14).
Axle
x 2
Figure 14. Wheels attached to axle.
-18-
Wheel
9. On opposite side of stand, insert pull handle
into holes shown in Figure 15 and secure
with (2) cotter pins.
Pull Handle
Figure 15. Cotter pins installed in handle.
10. Check to see if bandsaw is relatively level,
then fully tighten all bolts and nuts.
11. Slide work stop rod into side of bandsaw,
then lock it in place by tightening set screw
shown in Figure 16.
Work Stop Rod
Figure 16. Work stop rod installed.
Model G0926 (Mfd. Since 11/20)
x 2