Replacing Motor Brushes - Grizzly G0926 Owner's Manual

Replacing
Motor Brushes
This machine is equipped with a universal motor
that uses two carbon brushes to transmit electri-
cal current inside the motor.
These brushes are considered to be regular
"wear items" or "consumables" that will need to
be replaced during the life of the motor. The fre-
quency of required replacement is related to how
much the motor is used and how hard it is pushed.
Always replace both carbon brushes at the same
time when the motor no longer reaches full power,
or when the brushes measure less than
(new brushes are / " long).
5
8
If your machine is used frequently, we recom-
mend keeping a set of these replacement brushes
on-hand to avoid any downtime.
Items Needed
Phillips Head Screwdriver #2 ............................ 1
Flat Head Screwdriver
Carbon Brushes (P0926216) ............................. 2
To replace motor brushes:
1. DISCONNECT MACHINE FROM POWER!
2. Remove (5) Phillips head screws shown in
Figure 43 and motor cover.
x 5
Figure 43. Motor cover and securing Phillips
head screws.
Model G0926 (Mfd. Since 11/20)
/ " long
1
4
Qty
/ " ................................. 1
1
4
Motor Cover
3. Remove brush caps (see Figure 44) and
worn brushes from motor.
Brush Cap
(1 of 2)
Figure 44. Motor brush cap location.
4.
Replace both motor brushes and install brush
caps.
5.
Install motor cover and secure with Phillips
head screws removed in Step 2.
-37-