Carrying Tool; Optional Accessories; Maintenance - Makita 2712 Instruction Manual

► Fig.27
(3) When the width of rip is narrower than 65
mm, the push stick cannot be used because
the push stick will strike the blade guard. Use
the auxiliary fence and push block. Attach
the auxiliary fence to the rip fence with two
"C" clamps.
► Fig.28: 1. Auxiliary fence
Feed the workpiece by hand until the end
is about 25 mm from the front edge of the
table. Continue to feed using the push block
on the top of the auxiliary fence until the cut
is complete.
► Fig.29: 1. Workpiece 2. Push block
Cross cutting
CAUTION:
• When making a crosscut, remove the rip fence
from the table.
• When cutting long or large workpieces, always
provide adequate support to the sides of the
table. The support should be at the same height
as the table.
• Always keep hands away from path of blade.
► Fig.30: 1. Rip fence 2. Knob
Slide the rip fence into the rail on the table. Loosen the
knob on the fence and align to desired angle (0° to 60°).
Bring stock flush up against fence, secure it with the
clamp on the rip fence and feed gently forward into the
blade.

Carrying tool

► Fig.31
Make sure that the tool is unplugged.
Carry the tool by holding the tool part shown in the
figure.
CAUTION:
• Always secure all moving portions before carry-
ing the tool.
• Always make sure that the blade guard is
installed in place before carrying the tool.

MAINTENANCE

CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspec-
tion or maintenance.
• If the push block handle or push sticks is bro-
ken, contact Makita service center to get the
replacement.
NOTICE:
• Never use gasoline, benzine, thinner, alcohol or
the like. Discoloration, deformation or cracks may
result.
Cleaning
Clean out sawdust and chips from time to time.
Carefully clean the blade guard and moving parts inside
the table saw.
OPTIONAL
ACCESSORIES
CAUTION:
• These accessories or attachments are recom-
mended for use with your Makita tool specified
in this manual. The use of any other accessories
or attachments might present a risk of injury to
persons. Only use accessory or attachment for
its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Rip fence
• Wrench
• Hex wrench
NOTE:
• Some items in the list may be included in the
tool package as standard accessories. They
may differ from country to country.
13 ENGLISH