Table of Contents
Advertisement
Use of wood facing helps to assure splinter-free cuts
in workpieces. Attach a wood facing to the guide fence
using the holes in the guide fence.
See the figure concerning the dimensions for a sug-
gested wood facing.
410
120
67
25
Unit: mm
NOTICE:
When the wood facing is attached, do
not turn the turn base with the handle lowered.
The blade and/or the wood facing will be damaged.
Groove cutting
WARNING:
Do not attempt to perform this type
of cut by using a wider type blade or dado blade.
Attempting to make a groove cut with a wider blade or
dado blade could lead to unexpected cutting results and
kickback which may result in serious personal injury.
WARNING:
Be sure to return the stopper arm to
the original position when performing other than groove
cutting. Attempting to make cuts with the stopper arm in the
incorrect position could lead to unexpected cutting results and
kickback which may result in serious personal injury.
For a dado type cut, perform as follows:
1.
Adjust the lower limit position of the circular saw
blade using the adjusting screw and the stopper arm to
limit the cutting depth of the circular saw blade. Refer to
the section for stopper arm.
2.
After adjusting the lower limit position of the circu-
lar saw blade, cut parallel grooves across the width of
the workpiece using a slide (push) cut.
1
► 1. Cut grooves with blade
3.
Remove the workpiece material between the
grooves with a chisel.
50
84
40-50
23 12
Carrying tool
Before carrying the tool, be sure to remove the battery
cartridge and all movable parts of the miter saw are
secured. Always check the following:
•
The battery cartridge is removed.
•
The carriage is at 0° bevel angle position and
secured.
•
The carriage is lowered and locked.
•
The carriage is fully slid to the guide fence and
locked.
•
The turn base is at the full right miter angle posi-
tion and secured.
•
The sub base (optional accessory) is stored and
secured.
Carry the tool by the handle or by holding both sides of
the tool base.
WARNING:
tion is for carrying and storage purposes only
and not for any cutting operations. The use of the
stopper lever for cutting operations may cause unex-
pected movement of the circular saw blade resulting
in kickback and serious personal injury.
CAUTION:
Always secure all moving portions
before carrying the tool. If portions of the tool move
or slide while being carried, loss of control or balance
may occur and result in personal injury.
CAUTION:
Be sure that the carriage elevation
is properly locked at its bottom by the stopper
lever. If the stopper lever is not engaged properly, the
carriage may jump up suddenly and cause personal
injury.
28 ENGLISH
Stopper lever for carriage eleva-
Advertisement
Table of Contents
