Maintaining The Brush Roll; Troubleshooting - Bissell PET HAIR ERASER 2897 Series Quick Start Manual

Maintaining the Brush Roll

Go to BISSELL.ca/support for tips on maintaining and replacing your vacuum.
1. Turn the machine OFF and 2. Twist the bottom screws
press the Foot Release Button with a coin to remove bottom
to disconnect the Motorized cover.
Cleaning Foot.
4. 5.
Reattach Brush Roll by Attach and secure bottom
inserting into the belt and cover.
pressing in to place.

Troubleshooting

Below are some of the issues you may run into. If you don't see the issue you're experiencing
below, visit BISSELL.ca/support.
Problem Possible Cause Remedies
Filter is dirty. Remove and rinse the filters. Allow enough time to dry properly before reinserting.
Vacuum
There is a clog in the vacuum. Remove the foot and Extension Wand from the Hand Vacuum. Check for debris buildup or
won't pick
clogs in each of these sections. Clear any debris or clogs before reassembling.
up dirt
Dirt Tank is not seated correctly. Remove the tank and reseat properly.
Dirt Tank is full. Empty the tank.
Dirt is
Filter is missing or dirty. Check to see if the filter is in place. Clean if necessary.
escaping from
the vacuum
There is a clog in the vacuum. Remove the foot and Extension Wand from the Hand Vacuum. Check for debris buildup or
clogs in each of these sections. Clear any debris or clogs before reassembling.
Wrong power mode is being used. Make sure switch is pushed all the way to Carpet Cleaning Mode.
Brush Roll
Brush Roll has lodged debris or other Unplug to reset brush motor, checking for and removing debris before turning ON. If
doesn't
entanglements, keeping the brush problem persists, disconnect foot, remove bottom cover and clear debris & suction path.
rotate
from rotating.
WARNING
To reduce the risk of fi re, electric shock or injury, turn power OFF and disconnect plug from electrical
outlet before performing maintenance or troubleshooting. Other maintenance or service not included in the manual should be
performed by an authorized service representative.
3.
Remove the Brush Roll cover
and clear any debris from Brush
Roll.
BISSELL.ca 7