Clean Radiator And Oil Coolers; Replace Fuel Filter - Toro Reelmaster 5200-D Service Manual

Clean Radiator and Oil Coolers

The radiator and oil cooler should be checked for dirt
and debris daily, and hourly if conditions are extremely
dusty or dirty.
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
If engine has been running, the radiator may be
hot and cause burns. Work on radiator only when
the engine and radiator are cool.
2. Open engine hood.
3. Clean engine area thoroughly of all dirt and debris.
4. Release latches and pull up on the screen to slide it
out of mounting tracks. Clean screen thoroughly with
water or compressed air.
5. Slightly raise oil coolers and pivot forward. Clean
both sides of oil coolers and radiator area thoroughly
with water or compressed air. Pivot oil coolers back into
position.
6. Install screen and close hood.

Replace Fuel Filter

Replace fuel prefilter periodically as recommended in
the maintenance schedules in Chapter 2 - Product Re-
cords and Manuals.
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Clean area where filter bowl mounts to filter head.
3. Remove filter bowl and clean mounting surface.
4. Remove filter element from the bowl and replace
with new filter.
5. Install filter bowl by hand until O-ring contacts mount-
ing surface.
Kubota Diesel Engines
CAUTION
2
1. Screen
1
1. Transmission oil cooler
2. Reel oil cooler
1
1. Fuel filter assembly
2. Filter bowl
3. O-ring
Page 3 - 10
2
1
Figure 15
2. Latch
3
2
Figure 16
3. Radiator
4
2
Figure 17
4. Filter element
5. Filter head
Reelmaster 5200-D/5400-D
5
3