Replacing The Air Filter; Changing The Engine Oil - Toro 20041 Operator's Manual

Replacing the Air Filter

Replace the air filter yearly; replace it more frequently
in dusty operating conditions.
Refer to Preparing for Maintenance on page 11.
1. Use a screw
driver to open the
air filter cover.
2. Replace the air
filter.
3. Install the cover.
12

Changing the Engine Oil

Change the engine oil after the first 5 operating
hours; change it yearly thereafter.
Run the engine a few minutes before changing the oil
to warm it. Warm oil flows better and carries more
contaminants.
Refer to Preparing for Maintenance on page 11.
1. Remove the
dipstick.
m-7314
2. Tip the mower
onto its left side to
drain the used oil
out through the oil
fill tube.
m-7315
3. Slowly pour oil into
the oil fill tube until the
oil level reaches the Full
line on the dipstick. Do
not overfill. (Max. fill:
20 oz., type: SAE 30W
detergent oil with an API
service classification of
SF, SG, SH, SJ, SL, or
higher.)
4. Install the dipstick securely.
5. Dispose of the used oil properly at a local
recycling center.
3352-568 Rev A
m-7310
m-7316
m-7310