Table of Contents
Advertisement
Connecting Your DVD Player with Component Output
Optional 15p - to - RCA (female) 3
cable (ADP-CV1)
Component video RCA 3
cable (not supplied)
You can connect your projector to a DVD player with component output or Video output. To do so, simply:
1. Turn off the power to your projector and DVD player.
2. If your DVD player has the component video (Y,Cb,Cr) output, use a commercially available component video cable
(RCA 3) and the optional 15-pin-to-RCA (female) 3 cable to connect your DVD player to the COMPUTER IN
connector on the projector.
For a DVD player without component video (Y,Cb,Cr) output, use common RCA cables (not provided) to connect a
composite VIDEO output of the DVD player to the Video Input of the projector.
3. Connect the supplied power cable. See page 22.
4. Turn on the projector and DVD player.
A component signal will be automatically displayed. If not, from the menu, select [Advanced] → [Signal Select] →
[Computer], and then place a check mark in the Component radio button.
NOTE: Refer to your DVD player's owner's manual for more information about your DVD player's video output requirements.
COMPUTER 1 IN
VIDEO IN
L/MONO
AUDIO
R
S-VIDEO IN
AUDIO
L/MONO
R
DVD player
Y
C b C r
L
R
Component
AUDIO OUT
2. Installation and Connections
AUDIO
COMPUTER 1 IN
AUDIO
COMPUTER 2 IN
AUDIO OUT
PC CONTROL
MONITOR OUT
AC IN
Audio Equipment
Audio cable (not supplied)
20
AUDIO IN
L
R
Advertisement
Table of Contents
