Table of Contents
Advertisement
Battery Installation 8771
1
Push the catch to the right
and remove the battery
holder.
Remote Control Precautions
• Handle the remote control carefully.
• If the remote control gets wet, wipe it dry immediately.
• Avoid excessive heat and humidity.
• If you will not be using the remote control for a long time, remove the battery.
• Do not place the battery upside down.
• Keep the coin cell battery out of reach of children so as not to allow them to swallow the cell battery.
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by the manufacturer.
Dispose of used batteries according to your local regulations.
Operating Range for Wireless Remote Control
7m/22 feet
30
30
• The infrared signal operates by line-of-sight up to a distance of about 22 feet/7 m and within a 60-degree angle of
the remote sensor on the projector cabinet.
• The projector will not respond if there are objects between the remote control and the sensor, or if strong light falls
on the sensor.
Weak battery will also prevent the remote control from properly operating the projector.
2
Remove the old Lithium coin cell
and install new one (CR2032).
Ensure that the side with the
mark "+" is up.
Remote sensor on projector cabinet
7m/22 feet
Remote control
30
30
12
1. Introduction
3
Push the battery holder back into
the remote control until you feel a
click.
Advertisement
Table of Contents
