Raytheon 138-118 Manual page 30

Procedure for NMEA2:
-- Switch 2 of the DIP--Switch into the upper position.
Operation of push
after switching (B20)
switch 2 into the up-
*Adjustment of turn rate see section 4.2.1.4
-- By each operation of push button B23 annother format is selected and displayed.
-- This adjustment has to be performed for each connected channel and there for each
selected NMEA interface.
-- Each adjusted format has to be set wit push button B22 (right of the display).
The set format information blinks at the display.
-- After adjustment of all connected channels, the switch 2 has to be set
into lower position.
Please note:
Restrictions for NMEA channel 1 and NMEA channel 2.
On selection of NMEA repetition rate of 1 second, all selected telegrams can be trans-
mitted.
But on selection of NMEA repetition rate of 0.1 second, only 2 selected telegrams can
be transmitted.
More than 2 telegramms are not selectable at a repetition rate of 0.1 second.
3647.DOC010302
Distribution Unit
button B23
per position
1x
2x
3x
4x
5x
6x
7x
HCxxx--telegrams contain heading from magnetic com-
pass. Not all heading--receivers are allowed to used this
heading source.
Telegramtypes "HC" are transmitted from the respective
channel also, when a Gyro is selected at the connected
Operation Unit.
138- -118
Display
nME2
nME1.0
nM0.1
EHdT HEHDT--Telegram
CHdT HCHDT--Telegram
CHdG HCHDG--Telegram
IroT TIROT--Telegram*
EroT HEROT--Telegram*
22
Interface
NMEA Channel2
NMEA 1.0sec
NMEA 0.1sec
Edition: Feb. 23, 2004