4.2.1.2
Adjustment of the 8 output channels
Each of the 8 output channels can be set to 3 different interfaces.
These interfaces are: Course bus, NMEA1 and NMEA2.
With the formats NMEA1 and NMEA2 to different configurations can be adjusted, these
configurations become active after selection (to the respective output channel).
For adjustment of this configurations see sections 4.2.1.3 and 4.2.1.4.
Procedure:
-- Switches 1, 2 and 3 of the DIP--Switch B20 into the upper position.
-- By each operation of push button B23 annother channel and/or another interface
referring to the selected channel is selected and displayed.
-- This adjustemt has to be performed for each connected channel.
-- Each adjustment of a format has to be set by operating push button B22 (right side of
the display). Set format blinks on the display.
-- After adjustment of all connected channels, the DIP switches 1, 2 and 3 must be
switched into the "DOWN" position again.
Edition: November 21, 2003
Distribution Unit
138- -118
19
DISTRIBUTION
UNIT
3647.DOC010302