Table of Contents
Advertisement
3rd:
Switch ON the Power Supply by ON/OFF switch.
4th:
Follow Function 1 or Function 2 to setting to setting your Power On Function.
sol 2:
Change the Jumper setting to JP1 2-3 closed. It allows you can use power button to Power On your
system, and you can setting BIOS again. In this condition you can choose use Function 1 (use Power
Button Power On) or use Function 2 (Use Keyboard Password/ Hot-key Power On) to setting your
system.
Q2:
When use Function 2 use keyboard Password/Hot-key Power On, there has keyboard error problem?
Answer: This is the Power Supply 5V stand by current too small can not drive the keyboard.
sol:
If your Power Supply 5V Stand By current is not enough to driver keyboard. You can not use keyboard
password/Hot-key power on Function, Please change the Jumper setting JP1 2-3 closed only can use
Function 1: Power Button Power On.
4-3 QUICK GUIDE
CPU BUS
CPU Installation
Dram Installation
Install Expansion Card
Connect cable, wires &
power supplies
Bios Configuration
Clear CMOS
Bios Setup
Figure A
Set Front Side Bus (FSB) 66 or 100 according to your CPU.
CPU
Pg.6
JP1
Intel Pentium II 350
Intel Celeron 366
Pg.8
Pg. 8
Please follow manufacturer instruction for any expansion card
Pg.9
installed.
Refer to page 4 Fig. 2-1 to identify Pin No.1 connector on the
Pg.
10-14
motherboard. (Black dot indicates Pin No.1).
Red line on the ribbon cable indicates Pin No.1.
Pg. 6
Short Pin 2-3 for 3 to 5 seconds on JP13 to clear CMOS.
Pg. 6
=
FSB
=
100
=
66.6
43
x
Ratio
x
3.5
x
5.5
Advertisement
Table of Contents
