Pnp/Pci Configuration Setup - JETWAY 911BF User Manual

PCI PIRQ[A-D] #

3-6 PnP/PCI CONFIGURATION SETUP

This section describes configuring the PCI bus system. PCI, or Personal Computer
Interconnect, is a system which allows I/O devices to operate at speeds nearing the speed the
CPU itself uses when communicating with its own special components. This section covers
some very technical items and it is strongly recommended that only experienced users should
make any changes to the default settings.
PnP OS Installed
Reset Configuration Data
Resources Controlled By
 IRQ Resources
 DMA Resources
 Memory Resources
PCI/VGA Palette Snoop
Move Enter: Select +/-/PU/PD: Value F10:Save ESC: Exit F1:General Help
F5:Previous Values
 PnP OS Installed: This item allows you to determine install PnP OS or not.
The choice: Yes, No.
 Reset Configuration Data: Normally, you leave this field Disabled. Select Enabled to
reset Extended System Configuration Data (ESCD) when you exit Setup if you have
installed a new add-on and the system reconfiguration has caused such a serious conflict
that the operating system can not boot.
The choice: Enabled, Disabled .
 Resource controlled by: Auto will allow the Award Plug and Play BIOS to automatically
configure all of the boot and Plug and Play compatible devices. If you have trouble in
assigning the interrupt resource automatically you can select "manual", it will allow you to
choose specific resources by going into each of the sub menu that follows this field (a sub
menu is preceded by a "").
The choice: Auto(ESCD), Manual .
CMOS Setup Utility – Copyright © 1984-1998 Award Software
PnP/PCI Configurations
F6:Optimal defaults
No
Disabled
Menu Level
Manual
Press Enter Default is Disabled.
Select Enabled to
Press Enter
reset Extended System
Press Enter
Configuration
Data(ESCD) when you
Disabled
exit Setup if you
have installed a new
add-on and the system
reconfiguration has
caused such a serious
conflict that the OS
cannot boot
F7:Standard Defaults
Figure 3-6
28
Item Help
