Transporting The Unit - Stihl FS 94 Instruction Manual

15 Transporting the Unit

WARNING
Make sure the carburetor is correctly adjusted.
The cutting attachment must not rotate when the
engine is idling.
Your machine is now ready for operation.
14.3 Stopping the Engine
► Depress the momentary contact stop switch –
the engine stops – release the stop switch – it
springs back to the run position.
14.4 Other Hints on Starting
Engine stalls in cold start position g.
► Depress throttle trigger lockout and pull the
throttle trigger – the choke knob moves to the
Run F position.
► Continue cranking in position F until the engine
runs.
Running engine stalls in cold start position g or
under acceleration.
► Continue cranking in position F until the engine
runs.
If the engine does not start
► Check that all settings are correct.
► Check that there is fuel in the tank and refuel if
necessary.
► Check that the spark plug boot is properly con‐
nected.
► Repeat the starting procedure.
Engine is flooded
► Move the choke knob to F and continue crank‐
ing until the engine runs.
Fuel tank run until completely dry
► After refueling, depress the manual fuel pump
bulb at least five times – even if the bulb is
already filled with fuel.
► Set the choke knob according to engine tem‐
perature.
► Now start the engine.
15 Transporting the Unit
15.1 Using Transport Guard
The type of transport guard depends on the
metal cutting attachment supplied with the
machine. Transport guards are available as spe‐
cial accessories.
0458-593-8321-C
15.1.1 230 mm grass cutting blades
15.1.2 Grass Cutting Blades up to 260 mm
English
27