Stihl FS 94 Instruction Manual page 14

English
"Approved Combinations of Cutting Attachment,
Deflector, Handle and Harness".
The barrier bar is included with the machine or is
available as a special accessory.
6.2 Mounting the Loop Handle with
Barrier Bar
2
► Insert the square nuts (1) in the barrier bar (2)
– the holes must line up
14
1
1
6 Mounting the Loop Handle
4
5
6
► Insert the clamp (3) in the loop handle (4) and
position them together on the shaft (5)
► Position the clamp (6) against the shaft
► Position the barrier bar (2) – note position!
► Line up the holes
► Insert the screws (7) in the holes and screw
them into the barrier bar as far as they will go
► Go to "Securing the Loop Handle"
2
3
7
0458-593-8321-C